how to reset dyson air purifier without remote

For those of you who own a Dyson purifier, you know how it can be. You get a new puppy and in comes the dog hair all over the house. The dog also produces so much dung that it looks like snow outside. However, with regular use, your home will be clean once again.

With that being said, there are instances when you need to reset your purifier without using the remote control. Maybe because you moved it to a different room or perhaps your cat jumped on top of it and knocked out some of the dirt inside.

Whatever the case may be, this tips will tell you how to reset your Dyson purifier without using the remote control.

Note that you should check if there is any dirt still inside before attempting this as this could cause damage to your machine if there’s too much trapped inside.

How to Reset a Dyson Air Purifier

Without Using the Remote Control First, you need to turn on the machine. Next, pause the machine and allow it to cool down for a few minutes as it will be easier when it’s out of use.

Now, locate the filter cover. It’s located near the bottom of your machine where the dirt falls into. With one hand, pry open the filter cover with a gentle force and then release it with your other hand. There should be a window inside that allows you to see what is happening inside.

The filter will start spinning around in circles as this is how Dyson air purifiers are designed to clean themselves. Just wait for about 30-45 seconds until everything has been cleaned up and removed from your machine.

Dirt inside your Dyson Air Purifier?  How to Reset without Remote If you find that there’s still some dirt trapped inside after following this process, here are three more tips to help you get rid of it.

To start with, make sure that the room is well ventilated before attempting this or else all of your efforts may not work out too well for you! You’ll want to gently shake your machine as if there was an insect stuck in between two pieces of paper but don’t do this too hard because then that may cause damage.

If these two methods don’t work for you, try turning off the power switch on your machine for about ten seconds and then turn it back on again like normal. This should remove any

Clean Out the Dust Bin

The first thing you need to do is remove the dust bin. Remove the lid and then open the front of it. You should see a metal bar that you can use to pull up on.

This will release all of the dirt from inside of your machine so that you can clean it out well before attempting to reset it.

Just make sure not to touch any of the parts inside as this could cause damage if there’s too much dirt in there.

Reset Using the Remote Control

If you have the remote control, then that’s the best way to reset your air purifier. If you don’t have a remote control, then the steps below should help you:

1. Push the button on top of your Dyson purifier and release it when it is fully off.

2. Unplug both the power cord and electrical cable from their respective locations on your machine.

3. Simultaneously press and hold down the power button for 3 seconds to switch it back on.

4. Allow your machine to cool down for at least 20 minutes before plugging in the power cord again.

Turn it Off and Then On Again

The first thing to do is turn your machine off. If you have the remote control, then you can use that to help you out. However, if you don’t have a remote control, then there are other ways for you to turn it off even if it’s in the middle of cleaning up your home.

One way to do this is by pressing and holding on the power button for at least ten seconds. In addition, there’s also an emergency stop button located on the side of the unit so make sure that you check that out before turning it back on again.

When turning it back on, make sure that your purpose setting is set to normal operation mode so that it will resume cleaning as soon as possible once turned back on.

Check if It’s Working Properly

If you want to reset your Dyson, you should first make sure that it’s working properly. Look to see if the green light is on and if the motorized brush is spinning.

If the green light isn’t on, the machine is not going to turn on. You can use a vacuum cleaner attachment to clean out any dust or debris that could have built up in the machine.

Wrapping Up

Dyson purifiers are known to be the best in the market. They have an air-purifying system that works wonders on the entire house.

If you want your home to stay clean, you should invest in a Dyson purifier. They are not only effective but also do not require frequent replacement parts and maintenance. 

FAQs

How can you reset your Dyson purifier without using the remote control?

You can reset your Dyson purifier without using the remote control by following these simple steps:

Step 1 – Turn on your purifier and wait for it to fully heat up.

Step 2 – Empty out the dirt and debris that is inside of your purifier.

Step 3 – Confirm that the indicator light at the top of your purifier is flashing red.

Step 4 – Press on the reset button located on the bottom of your purifier. This will take you back to factory settings.

What are the different parts of your Dyson purifier?

There are a few different parts to a Dyson purifier but the most important are the filter and the motor head.

The filter keeps all of the pet hair, dust, and allergens from being released into your home. The motor head is what rotates inside the filter collecting all of that debris and then releasing it through a port into the canister.

This canister then contains any remaining dust and debris so that your home isn’t constantly filling up with it.